Home / Support

Blog - Support

Upgrade sport design steering wheel to multifunction coding guide

Upgrade sport design steering wheel to multifunction coding guide

Original with sport design steering wheel car(991.1/981/958/970) upgrade multifunction steering wheel,need coding the vehicle steering control module from sport style wheel to multifunction,input"Multifunction enable code" and coding the car by PIWIS.

If your Porsche original equipped sport style steering(With PDK shifts paddles version) and with sport chrono package,no "Multifunction enable code" needed,skip input enable code step.Coding the car to enable the ◊ button function assignment menu in instrument display,sport style steering wheel equipped car without  this setting menu.

997.2/987.2 Upgrade to MF steering wheel just need perform this step,select to "steering col.switch" unit and read and erase all fault memories,Then switch to "codings" and set "Multi-function or Sport/Launch display" as "installed"

Following coding guide for (991.1/981/958/970)

1.Connect PIWIS,Press F7 or select "Add Menu".

2.Select "Maintentance of vehicle data".

3.1 Uncheck old none multifunction steering wheel,Select new MF steering wheel installed.(991.1/981)

3.2 Select new MF installed.(970 Panamera/958.1 Cayenne)

4.Press F8 to save.

5.In the overview page Ctrl+A select all ECUs.

6.Select "Coding adaptations" run "Automatic coding".

7.Select "Steering-Wheel Electronic",enter "Maintenance repairs" select "Function enable"

8.Input the enable code you get and save.

9.Clear all faults code,IGNITION OFF the car,ignition on and enjoy new MF wheel.

997.1/987.1 upgrade to multifunction PDK shift peddles steering wheel coding guide

997.1/987.1 upgrade to multifunction PDK shift peddles steering wheel coding guide

997.1 replace steering control module hardware to 997.2 reference this article

997.1 upgrade to 997.2 steering wheel control module (997.613.289.01 or 997.613.299.01) need coding with PIWIS following this step:

1. Select "special functions" and do a "vehicle handover". 

 

2. The "vehicle handover" runs automatically. When prompted if the car is new, select "no" and then confirm your chassis number (VIN). The "vehicle handover" is needed for recognizing your new steering wheel unit, so that all other control modules are able to communicate with it. 

 

3. Select to "steering col. switch" unit and read and erase all fault memories. Then switch to "codings" and set "Automatic (Tiptronic/PDK)" and "PDK" (both!) to "installed". Also set "Multi-function or Sport/Launch display" and all your other values to "installed" if the car is equipped with them (for example speed control system)

 

4. Then select "PSM" unit and read and erase all fault memories. After that read your security code (The security code is read with the PIWIS2
under menu item "Actual values"
) and do a steering-wheel-sensor-calibration (security code is needed here). (some cars need this calibration clear PSM faults)

 

5. At last: Erase all fault memories and then have fun while driving a Tiptronic car with PDK-Paddles